Install and Fitment Information
Please read before ordering or installing your product.
Fitment Information
Panel Wraps
Panel Shape Information:
Our panel wrap kits are designed specifically to fit just inside the recess of the panel. This
means there will be approximately a 10mm gap between the print and edge of panel.
Our Vehicle outlines, although accurately to scale, may not give us the shape of the panel
100% perfect.
Most customers find this perfectly acceptable, but on occasion some customers
have reported they were not satisfied. We ask that your expectations meet this standard.
We supply our graphics to fit inside the recess with a small gap, as this makes the fitting
process much easier for DIY installer.
Above is a small example of how our panel wraps will fit. There will be a minimal space between the
printed panel and the edge of the recess. We can supply the print oversized for no extra cost, meaning you can install then trim them yourself for a perfect fit. If you choose this option, we hold no responsibility for any damage to the print or your vehicle.
Panel Fitment Information:
As we say, we design our panel wrap prints to fit within the panel recess. This means there will be up to a 25mm gap between the print and the edge of the panel recess (Depending on the vehicle).
You must position the print to sit in the middle of the panel - do not start at the edge of the
recess, as the print will not look right. For example, if you butt the left edge of the print to
the left edge of the recess (Leaving no gap), by the time the print is applied to the right
hand edge, there will be a large gap - Please see below:
If any of the above is not acceptable to you, we kindly ask you to either contact us before you place an order or simply seek alternative arrangements.